in bulk container or according to the customer's requirement
Shipped in 120 days after payment
The Triangular-lattice-girders are made from high tensile reinforcing bar, Lattice Girders being with a typical design comprising of one top bar (8-16mm), two bottom bars (8-12mm) and inclined ‘zigzag’ bars (8mm). The Lattice girders are made to your specification so we can accommodate virtually any height, width and length.
The Lattice girder welding machines produce standard lattice girders, thrust girders and wall girders.
Lattice girder applications: Often used in permanent precast concrete formwork to in-situ slabs, lattice girders provide rigidity to the unit and acts as a mechanical fixing between the precast formwork and the in-situ concrete.
Layout plan: Line wire pay-off → Line wire straightening unit → rod bending unit → welding system → cutting system → truss girder collector
1). Line wire pay-off………………..5sets
Max. Capacity: 1500Kg for each set.
2). Line wire straightening unit……………… 5sets
Each set can be controlled separately.
Emergency stop switch, keep personnel and equipment away from damage.
3). Inclined beading bending & molding structure
the height of the truss bridge is adjustable
4). Welding system
Set on the top and bottom side, motor control, adjusting the height of the truss bridge
Adopting Pneumatic control system
5). Truss bridge cutting
Auto cutting in-phase, high efficiency
6). Material receiving system
Automatic material receiving & stacking system, chain type driving
7). Control system
² PLC control
² Electronical Component (Siemens brand)
² Set jointing control centre, fault a ming function
² All jointing data can be set and adjust facility
² including electronic control cabinet, operation platform.
Advantages of Lattice girder machines:
Extremely short times for changing of height and dimensions.
Setting of welding control via monitor and examination of welding points.
Special welding electrodes which are not replaced when worn out but simply turned forward by one increment.
High reliability of the process due to flexible stacking for girder packs of different lengths.
Stacking by order reference is possible.
Easy maintenance of all plant components.
Automatic reminder of maintenance upon reaching preset output meters.
Power supply voltage
380V ± 10% – 50Hz±1%
800KVA (Average: 80KVA)
Installed power for rest of machine
Consumption (filtered, dried, no water, no oil)
Operational pressure (constant)
Consumption (clean, filtered, no residues, no calcium, no deposits)
Min pressure (constant)
0.2 – 0.3Mpa
Max temperature at inlet
0 – 40°C
FeB44K, FeB32K, FeB38K (weldable)
Unitary yield stress
Unitary tensile stress
Longitudinal wire diameter (upper)
Longitudinal wire diameter (lower)
Diagonal wire diameter
GIRDER PRODUCTION LINE
Production rate (maximum)
Girder internal base width
6m or at customer’s requirement
Multiples of 200mm
Packaging & Shipping
Within the limits of what hereinafter set forth, ANBER undertakes to remedy all defects of the equipment attributable to its engineering, material and workmanship. Such obligation of ANBER is limited to defects that show within 12 (twelve) months from the delivery of the equipment. To benefit from these rights, Buyer shall notify within 8 days of its discovery to ANBER, in writing, analytically and precisely, all shown defects.
Installation and commissioning
Machine is installed and commissioned by ANBER technicians. Testing cost, travel, accommodation and meal expenses are payable by the customer, the customer will provide local engineers and staff to support the installation.